You will need pozi and metric hex drivers for these procedures. All SSL hardware is metric. Philips can be used but you must be careful to not strip screw heads.
Please familiarize yourself with the instructions in full to ensure that you have sufficient time and technical skills to complete the procedure. If you would prefer an SSL engineer to perform the procedure, please contact your local SSL distributor.
These instructions are intended for technically competent personnel. To reduce the risk of electric shock, do not perform the procedure unless you are competent to do so.
Electrostatic discharge (ESD) can damage electrical components, even if you cannot feel, see, or hear it. Before starting work, grasp an exposed metal part of the console chassis with your bare hand to ground any static charge which you may have accumulated.
Switch off and disconnect the mains supply before removing any panels or modules.
Large capacitors such as those in power supplies can store dangerous voltages even if the console has been disconnected. To reduce the risk of electric shock, allow up to 20 minutes for capacitors to discharge after isolating the mains supply before starting work on any high voltage modules.
When using solvents, wear suitable eye protection at all times. Ensure adequate ventilation to prevent buildup of vapour and work well away from possible sources of ignition.
AC and Analog PSU's
Bus compressor cards (629928Xn)
Left hand (centre section) cards
Right hand (centre section) cards
Channel solo/cuts panels